LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator Tube Bolt
    GM824412Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the O-ring seal onto the oil level indicator tube.
  3. Install the oil level indicator tube behind the exhaust manifold.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Install the oil level indicator tube into the block. The tube must be installed with the collar flush to the block.
  6. Lower the vehicle.
    7. NOTE: Refer to Fastener Notice .
  7. Install the oil level indicator tube bolt

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

  8. Position the coolant recovery reservoir and install the retaining bolt.
  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals