LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the oil level sensor to the oil pan.

    Tighten:  Tighten the oil level sensor to 13 N.m (115 lb in).

    2. Fig 2: Identifying Electrical Connector (Right Side Of Engine)
    GM662991Courtesy of GENERAL MOTORS CORP.
  2. Connect the oil level sensor electrical connector (6).
  3. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals