LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Engine Mount Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mount To Engine Mount Bracket Bolts
    GM829685Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the starter. Refer to Starter Motor Replacement (4.8L, 5.3L, and 6.0L) .
  3. Remove the right side exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (4.8L, 5.3L, 6.0L) .
  4. Remove the engine mount to the frame mounting bolts.
    5. NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.
    IMPORTANT: Raise the engine only enough to permit removal of the engine mount.
  5. Raise and suitably support the engine using adjustable (screw type) jackstands.
    6. Fig 2: Engine Mount To Engine Mounting Bolts
    GM829673Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount to the engine mounting bolts.
  7. Remove the engine mount from the vehicle.
scientia non olet · About LEMON Manuals