LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Engine Mount Bracket Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mount To Engine Mount Bracket Bolts
    GM829685Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Engine Mounting Notice .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine mount to engine mount bracket bolts.
    3. Fig 2: View Of Square Tab At Rear Of Engine Block
    GM374320Courtesy of GENERAL MOTORS CORP.
    NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.
    IMPORTANT: Raise the engine only enough to permit removal of the engine mount bracket.
  3. Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.
    4. Fig 3: Engine Mount Bracket Mounting Nuts
    GM829676Courtesy of GENERAL MOTORS CORP.
  4. Remove the engine mount bracket mounting nuts
  5. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals