LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> On-Vehicle REPARI Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel & Bolt
    GM178458Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the position and direction of the engine flywheel before removal.
  1. Remove the automatic transmission, if equipped. Refer to Transmission Replacement for the 4L60-E transmission or Transmission Replacement for the 4L80-E transmission.
  2. Remove the engine flywheel bolts.
  3. Remove the automatic transmission engine flywheel.
  4. Clean and inspect the engine flywheel. Refer to Engine Flywheel Cleaning and Inspection .
  5. Install 2 M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  6. Rotate the bolts clockwise to remove the spacer.
    7. Fig 2: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
  7. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals