LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Mechanical - 4.8L, 5.3L, And 6.0L (2 Of 4)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Crankshaft Balancer Removal

Crankshaft Balancer Removal

WARNING: This page is about a different variant/trim than selected.

Tools Required

    Fig 1: Using J 42386-A To Lock Flywheel
    GM260126Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT:
    • Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
    • Ensure the teeth of the flywheel holding tool mesh with the teeth of the engine flywheel.
  1. Install the J 42386-A  and bolts. See Special Tools .

    Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

    Tighten:  Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).

    2. Fig 2: Identifying Crankshaft Balancer And Retaining Bolt
    GM260154Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt.

    Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.

    3. Fig 3: Removing The Crankshaft Balancer
    GM156164Courtesy of GENERAL MOTORS CORP.
  3. Use the J 41816-A  and the J 41816-2  in order to remove the crankshaft balancer. See Special Tools .
  4. Remove the J 42386-A  and bolts. See Special Tools .
scientia non olet · About LEMON Manuals