LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Transfer Case - BW 4473-NP3) >> Repair Instructions - On Vehicle >> Transfer Case Output Shaft Seal Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Transfer Case Seal Removal Notice .
    Fig 1: Identifying Rear Output Shaft Seal
    GM823202Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement .
  3. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.
scientia non olet · About LEMON Manuals