LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Vehicle Speed Sensor & O-Ring Seal
    GM97102Courtesy of GENERAL MOTORS CORP.
  1. Install the speed sensor and the O-ring seal into the transmission.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  3. Install the electrical connector to the speed sensor.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals