LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Filler Tube and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission fluid level indicator from the fluid fill tube.
  2. Remove the engine cover. Refer to Engine Cover Replacement .
    3. Fig 1: Identifying Transmission Fluid Fill Tube Bracket Bolt
    GM103669Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt securing the transmission fluid fill tube bracket to the engine.
  4. Remove the nut securing the transmission fluid fill tube bracket to the transmission. Remove the upper transmission fill tube from the vehicle.
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the transmission pan drain plug. Drain the fluid into an approved container.
  7. Remove any dirt from the transmission where the fluid fill tube enters the transmission case.
  8. Remove the transmission fluid fill tube from the transmission. Pull the tube upward from the transmission.
  9. Remove the transmission fill tube seal.
  10. Clean the metal parts using solvent. Do not allow the solvent to enter the transmission.
  11. Air dry the parts.
scientia non olet · About LEMON Manuals