LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Transmission Fluid Fill Tube Bracket Bolt
    GM103669Courtesy of GENERAL MOTORS CORP.
  1. Install a new oil level indicator tube seal into the transmission case.
  2. Install the oil level indicator tube into the seal.
  3. Lower the vehicle.
  4. Install the upper transmission fill tube to the vehicle and into the lower fill tube.
    5. NOTE: Refer to Fastener Notice .
  5. Install the nut securing the oil level indicator tube bracket to the transmission.

    Tighten:  Tighten the nut to 6 N.m (53 lb in).

  6. Install the bolt securing the oil level indicator tube bracket to the engine.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in).

  7. Fill the transmission to the proper fluid level. Refer to Fluid Capacity Specifications and to Transmission Fluid Check .
scientia non olet · About LEMON Manuals