Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Auxiliary Oil Cooler & Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Install the 4 bolts securing the oil cooler to the radiator support.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the oil cooler lines to the auxiliary oil cooler. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
Tighten: Tighten the cooler lines to 23 N.m (17 lb ft).
Remove the drain pan.
Install the grille assembly. Refer to Grille Replacement (Base) or Grille Replacement (Uplevel) .