LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Adjustment

Range Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Automatic Transmission Range Selector Cable
    GM105219Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission shift control lever into park.
  2. Apply the park brake.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the end of the range selector cable from the range selector lever ball stud.
  5. Position the transmission range selector lever to park. Rotate the range select lever clockwise until it reaches the full mechanical stop position.
  6. Slide the locking tab retainer to the side.
  7. Release the locking tab.
  8. Install the end of the range selector cable to the range selector lever ball stud.
  9. Engage the locking tab without disturbing the cable. This sets the adjustment.
  10. Slide the locking tab retainer over the locking tab.
  11. Lower the vehicle.
  12. Check the transmission for proper operation.
  13. Release the parking brake.
scientia non olet · About LEMON Manuals