LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Automatic Transmission Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Shift Cable-To-Steering Column Bracket Retaining Clip
    GM765121Courtesy of GENERAL MOTORS CORP.
  1. Apply the parking brake.
  2. Position the steering column shift lever to park.
  3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Replacement .
  4. Remove the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
  5. Remove the clip securing the shift cable to the steering column bracket.
  6. Remove the shift cable from the steering column shift control.
  7. Pull back the carpet and insulation to gain access to the shift cable pass-through grommet.
  8. Remove the rubber grommet from the floor panel.
  9. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    10. Fig 2: Shift Cable Removed
    GM765122Courtesy of GENERAL MOTORS CORP.
  10. Remove the shift cable from the stud ball.
  11. Remove the locking clip from the cable at the bracket.
  12. Unclip the cable from the retainers at the fuel lines and body.
  13. Lower the vehicle.
  14. Remove the shift cable from the vehicle.
scientia non olet · About LEMON Manuals