Removal Procedure

Tools Required

• J 8092  Universal Driver Handle - 3/4 in - 10
• J 7004-A  Universal Remover. See Special Tools .
• J 23907  Slide Hammer with Bearing Adapter. See Special Tools .
• J 25019-14  Stator Pump Bushing Remover. See Special Tools .
• J 29369-2  Bushing and Bearing Remover 2-3 in. See Special Tools .
• J 34196-B  Transmission Bushing Service Set. See Special Tools .

Fig 1: Identifying Reaction Carrier Components
Courtesy of GENERAL MOTORS CORP.
1. Remove the reaction carrier shaft/internal gear retainer (668) and the reaction carrier shaft (666) from the input internal gear (664).
2. Inspect the reaction carrier shaft (666) and the input internal gear (664) for the following defects:
   • Scoring
   • Cracking
   • Damaged or worn bushings
   • A cracked shaft
   • A damaged spline
   • Damaged gear teeth
Fig 2: Removing Reaction Carrier Shaft Front Bushing
Courtesy of GENERAL MOTORS CORP.
3. UsingJ 29369-2  with J 23907  , remove the reaction carrier shaft front bushing (665). See Special Tools .
Fig 3: Using J 25019-14 & J 25019-14 To Remove Reaction Carrier Shaft Rear Bushing
Courtesy of GENERAL MOTORS CORP.
4. UsingJ 25019-14  with J 7004-A  , remove the reaction carrier shaft rear bushing (667). See Special Tools .