Output Shaft Installation

WARNING: This page is about a different variant/trim than selected.

Tools Required

J 29837-A Output Shaft Support Fixture. See Special Tools .

Fig 1: View Of Output Shaft

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.

Install the output shaft (687).

Fig 2: Identifying Special Tool J29837-A & Output Shaft O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Install the J 29837-A as shown. See Special Tools . Support the output shaft (687) with adjustable stop (1).