LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Oil Pump Stator Shaft Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Special Tools J 21465-2, J 8092 & New Starter Shaft Front Bushing
    GM1552960Courtesy of GENERAL MOTORS CORP.
  1. Using the J 21465-2  (1) and the J 8092  (2), install a new stator shaft front bushing (234). See Special Tools .
    2. Fig 2: Identifying Special Tools J 34196-B, J 8092 & Starter Shaft Rear Bushing
    GM1552961Courtesy of GENERAL MOTORS CORP.
  2. Using the J 34196-2 (1) which is part of kit J 34196-B  and the J 8092  (2), install the stator shaft rear bushing (241). See Special Tools .
scientia non olet · About LEMON Manuals