Oil Pump Body Assemble

Tools Required

• J 25016  Pump Seal and Speedometer Gear Installer. See Special Tools .
• J 36850  Transjel Lubricant. See Special Tools .

Fig 1: Installing Oil Seal Assembly
Courtesy of GENERAL MOTORS CORP.
1. Using the J 25016  (1), install the oil seal assembly (243). See Special Tools .
Fig 2: View Of Fluid Seal Retainer
Courtesy of GENERAL MOTORS CORP.
2. Install the fluid seal retainer (244).
Fig 3: Identifying O-Ring Seal & Oil Seal Ring
Courtesy of GENERAL MOTORS CORP.
3. Install an O-ring seal (202) and oil seal ring (201) into the groove on the back side of the pump slide (203).
4. Use J 36850  , or an equivalent, to retain the seal and the ring on the slide. See Special Tools .
5. Install the pivot pin spring (204) into the pump body pocket.
6. Install the seal support (208) and the pump slide seal (209) into the pump slide (203). Retain with J 36850  or equivalent. See Special Tools .
7. Install the pump slide (203).

   The oil seal ring must face downward into the pump pocket.

8. Install the pivot pin (205), index the slide notch with the pivot pin.
Fig 4: Identifying Fluid Pump slide Outer Spring
Courtesy of GENERAL MOTORS CORP.
9. Install the fluid pump slide outer spring (245).
Fig 5: Identifying Pump Vane Ring, Rotor Guide & Rotor
Courtesy of GENERAL MOTORS CORP.
10. Install the rotor guide (211) and the bottom pump vane ring (210) into the rotor (212) and retain with J 36850  or an equivalent. See Special Tools .
11. Install the rotor (212) with the rotor guide (211) toward the pump pocket.
12. Install the pump vanes (213). Ensure the vanes are flush with the oil pump body surface.
13. Install the top pump vane ring (210).