LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Low and Reverse Clutch Plate Installation

Low and Reverse Clutch Plate Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Illustrating Steel Plate Spline Alignment
    GM5491Courtesy of GENERAL MOTORS CORP.
  1. Install the waved plate.
  2. Install the correct selective spacer plate (from the selection procedure).
  3. Install the five fiber plate assemblies and four steel plates, starting with one fiber plate assembly and alternating with steel.
  4. Index the steel plate splines in the case as shown.
scientia non olet · About LEMON Manuals