LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Input Speed Sensor Removal

Input Speed Sensor Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Speed Sensor (ISS) Retaining Bolt
    GM1552933Courtesy of GENERAL MOTORS CORP.
  1. Remove the input speed sensor (ISS) retaining bolt (247).
  2. Use a small tipped screwdriver to carefully pry the ISS wiring harness retaining brackets from the pump housing. Being careful not to damage retainer clips.
  3. Remove the ISS assembly (250).