Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the engine cover. Refer to Engine Cover Replacement .
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Remove the positive crankcase ventilation hose from the valve rocker arm cover.
- Disconnect the engine coolant temperature (ECT) gage sensor electrical connector.
- Remove the ECT gage sensor connector from the bracket.
- Remove the spark plug wires for the left side of the engine from the distributor cap.
- Remove the air conditioning compressor discharge hose, if equipped.
- Remove the air conditioning compressor suction hose, if equipped.
- Remove the valve rocker arm cover bolts.
- Remove the valve rocker arm cover.