LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Valve Rocker Arm Cover Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Rocker Arm Cover And Gasket
    GM328573Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the valve cover gasket or the valve rocker arm cover bolt grommets.
  1. Install the NEW valve rocker arm cover gasket into the groove of the valve rocker arm cover.
  2. Install the NEW valve rocker arm cover bolt grommets into the valve rocker arm cover.
    3. Fig 2: Valve Rocker Arm Cover (Left)
    GM480519Courtesy of GENERAL MOTORS CORP.
  3. Install the valve rocker arm cover onto the cylinder head.
    4. Fig 3: Valve Rocker Arm Cover Bolts (Left)
    GM328566Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the valve rocker arm cover bolts.

    Tighten:  Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

  5. Install the air conditioning compressor discharge hose, if equipped.
  6. Install the air conditioning compressor suction hose, if equipped.
    7. Fig 4: Bracket ECT Gage Sensor Connector
    GM543569Courtesy of GENERAL MOTORS CORP.
  7. Connect the spark plug wires to the distributor cap.
  8. Install the ECT gage sensor electrical connector to the bracket.
  9. Connect the ECT gage sensor electrical connector.
    10. Fig 5: Valve Rocker Arm Cover Positive Crankcase Ventilation Hose
    GM1545576Courtesy of GENERAL MOTORS CORP.
  10. Install the PCV hose to the valve rocker arm cover.
  11. Install the engine cover. Refer to Engine Cover Replacement .
  12. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals