LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Coolant Recovery Reservoir Bolt
    GM374484Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Remove the bolt holding the coolant recovery reservoir and set the reservoir aside.
  3. Remove the oil level indicator.
  4. Remove the screw holding the oil level indicator and the transmission fluid fill tube to the oil fill tube lower support.
    5. Fig 2: Upper & Lower Oil Level Indicator Tubes
    GM183393Courtesy of GENERAL MOTORS CORP.
  5. Remove the top half of the oil level indicator tube from the bottom half.
  6. Clean the old sealer from the tube.
    7. Fig 3: Locating Oil Level Indicator Tube Bolt
    GM172977Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil level indicator tube bolt.
  8. Remove the oil level indicator tube from the engine using a twisting motion.
  9. Clean the old sealer from the oil level indicator tube and the engine block.
scientia non olet · About LEMON Manuals