LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Applying Sealant & Installing Oil Level Indicator Tube & Bolt
    GM188009Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant around the oil level indicator tube 13 mm (0.5 in) below the tube bead. Refer to Sealers, Adhesives, and Lubricants  for the correct part number.
  2. Install the oil level indicator tube into the engine block. Rotate the oil level indicator tube into position.
    3. Fig 2: Upper & Lower Oil Level Indicator Tubes
    GM183393Courtesy of GENERAL MOTORS CORP.
  3. Apply sealer on the upper oil level indicator tube to the area where it fits into the lower half. Refer to Sealers, Adhesives, and Lubricants  for the correct part number.
  4. Install the oil level indicator tube upper half to the lower half.
    5. Fig 3: Coolant Recovery Reservoir Bolt
    GM374484Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the bolt that holds the oil level indicator tube and the transmission fluid fill tube to the oil fill tube lower support.

    Tighten:  Tighten the oil fill level indicator tube and the transmission fluid fill tube to lower support bolt to 5 N.m (44 lb in).

  6. Install the oil level indicator.
  7. Install the engine cover. Refer to Engine Cover Replacement .
  8. Position the coolant recovery reservoir and install the bolt.
scientia non olet · About LEMON Manuals