LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying J 41712
    GM348108Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Disconnect the engine oil pressure gage sensor electrical connector.
  3. Hold the engine oil pressure gage sensor fitting with a wrench.
  4. Remove the engine oil pressure gage sensor using J 41712  . See Special Tools .
    5. Fig 2: View Of Engine Oil Pressure Gage Sensor Fitting
    GM348110Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the alignment of the engine oil pressure gage sensor fitting prior to removal.
  5. Remove the engine oil pressure gage sensor fitting, if necessary.
scientia non olet · About LEMON Manuals