LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Oil Pressure Gage Sensor Fitting
    GM348110Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the engine oil pressure gage sensor fitting, if removed.

    Tighten: 

    1. Tighten the engine oil pressure gage sensor fitting to 15 N.m (11 lb ft).
      2. IMPORTANT: Do not loosen the sensor fitting. Do not tighten the sensor fitting more than one turn to align.
    2. Tighten the sensor fitting until properly align.

    2. Fig 2: Identifying J 41712
    GM348108Courtesy of GENERAL MOTORS CORP.
  2. Install the engine oil pressure gage sensor.
  3. Hold the engine oil pressure gage sensor fitting with a wrench to prevent from turning.

    Tighten:  Using J 41712  tighten the engine oil pressure gage sensor to 30 N. See Special Tools .m (22 lb ft).

  4. Connect the engine oil pressure gage sensor electrical connector.
  5. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals