Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Mount To Frame Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Engine Mounting Notice .

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the starter. Refer to Starter Motor Replacement (4.3L) .
Remove the engine mount to frame mounting bolts.

Fig 2: View Of Square Tab At Rear Of Engine Block

Courtesy of GENERAL MOTORS CORP.

NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

IMPORTANT: Raise the engine only enough to permit removal of the engine mount.

Use a jack on the square tab at the rear of the engine block, and raise the engine, left side shown.

Fig 3: Engine Mount To Engine Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the engine mount to engine mounting bolts.
Remove the engine mount from the vehicle.