LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mount To Engine Mounting Bolts
    GM829670Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the engine mount to engine mounting bolts.

    Tighten:  Tighten the engine mount to engine mounting bolts to 50 N.m (37 lb ft).

  3. Lower the engine.
    4. Fig 2: Engine Mount To Frame Mounting Bolts
    GM829683Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount to the frame mounting bolts.

    Tighten:  Tighten the engine mount to frame mounting bolts to 60 N.m (44 lb ft).

  5. Install the starter. Refer to Starter Motor Replacement (4.3L) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals