LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly. Refer to Transmission Replacement .
  2. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    3. Fig 1: Crankshaft Rear Oil Seal Notches
    GM31379Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft rear oil seal from the crankshaft rear oil seal housing.

    Insert a suitable tool into the access notches and then carefully pry the crankshaft rear oil seal from the crankshaft rear oil seal housing.

  4. Discard the crankshaft rear oil seal.
  5. Clean off any dirt or rust in the area.
scientia non olet · About LEMON Manuals