LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Do not remove the crankshaft rear oil seal housing if only replacing the crankshaft rear oil seal.
  1. Remove the oil pan. Refer to Oil Pan Replacement .
  2. Remove the transmission assembly. Refer to Transmission Replacement .
  3. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    4. Fig 1: Crankshaft Rear Oil Seal Housing & Bolts
    GM524317Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts and the nut holding the crankshaft rear oil seal housing to the engine.
  5. Remove the crankshaft rear oil seal housing.
    6. Fig 2: Locating Crankshaft Rear Oil Seal Housing Gasket
    GM524322Courtesy of GENERAL MOTORS CORP.
  6. Remove and discard the crankshaft rear oil seal housing gasket.
  7. Clean all the sealing surfaces.
  8. Inspect the crankshaft rear oil seal housing for warping, cracks, wear, or damage.
scientia non olet · About LEMON Manuals