LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - Off Vehicle >> Oil Pump Installation

Oil Pump Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pump Locator Pins
    GM330578Courtesy of GENERAL MOTORS CORP.
  1. Inspect for properly installed oil pump locator pins.
    2. Fig 2: View Of Oil Pump
    GM330576Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the oil pump driveshaft retainer.
    During assembly, install a NEW oil pump driveshaft retainer.
  2. Install the oil pump.
  3. Position the oil pump onto the pins.
    4. Fig 3: View Of Oil Pump Bolt
    GM330572Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the oil pump bolt attaching the oil pump to the rear crankshaft bearing cap.

    Tighten:  Tighten the oil pump bolt to 90 N.m (66 lb ft).

scientia non olet · About LEMON Manuals