LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.3L) >> Repair Instructions - Off Vehicle >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission Canister Solenoid Valve & Harness
    GM1523560Courtesy of GENERAL MOTORS CORP.
  1. Remove the evaporative emission (EVAP) canister purge solenoid valve harness.
    1. Push the quick disconnect clip and hold in place.
    2. Pull outward on the harness elbow.
    2. Fig 2: Intake Manifold Assembly & Bolts
    GM31510Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine coolant temperature (ECT) sensor wire connector, if equipped, from the engine wiring harness bracket.
  3. Remove the lower intake manifold bolts.
    4. IMPORTANT:
    • The intake manifold may be removed as an assembly. Do not remove the specific intake manifold components unless component service is required.
    • Do not allow dirt or debris to enter the fuel system. Ensure that the ends of the fuel system are properly sealed.
  4. Remove the intake manifold assembly.
  5. Remove and discard the lower intake manifold gaskets.
scientia non olet · About LEMON Manuals