Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Reprogramming the PCM may cause a communication error between the PCM and the TAC. If the PCM detects a communication error, DTC U0107 sets. Clear any DTCs from the memory that may have been set by reprogramming.
- DTC U0107 sets if the battery voltage is low. If the customer's concern is slow cranking or no crank because battery voltage is low, ignore DTC U0107. Clear any DTCs from memory that may have set from the low battery voltage condition.
- For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections .