With RPO JL4

DTCs P0030, P0036, P0050, P0053, P0054, P0056, P0059, P0060, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0160, P0161, P0200, P0442, P0443, P0446, P0449, P0455, P0496, P1125, P1133, P1134, P1153, P1154, P1516, P2101, P2108, P2135, U0107 are not set.

Passive Test

• The engine is running.
• The above conditions are met for 2 seconds.
• This diagnostic runs one time per drive cycle when the above conditions are met.

Intrusive Test

• The Engine Run Time parameter is more than 218 seconds.
• The ignition 1 Signal parameter is between 10-18 volts.
• The Engine Speed parameter is between 900-5,000 RPM.
• The MAF Sensor parameter is between 5-100 g/s.
• The Vehicle Speed parameter is between 24-131 km/h (15-82 mph).
• The Short Term FT Bank 1 and Bank 2 parameter is between -4 and +4 percent.
• The maximum number of intrusive attempts is less than 100.
• The above conditions are met for 3 seconds.
• This diagnostic runs one time per drive cycle when the above conditions are met.