Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0200, P0300, P0442, P0446, P0452, P0453, P0455, P0496 are not set.
The Engine Coolant Temperature (ECT) Sensor parameter is more than 60°C (140°F).
The Evaporative Emission (EVAP) Purge Solenoid Command parameter is more than 1 percent.
The Mass Air Flow (MAF) Sensor parameter is between 20-55 g/s.
The Engine Speed parameter is between 1,200-3,000 RPM.
The Throttle Position (TP) Sensor parameter is more than 5 percent.
The Loop Status parameter is closed.
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Tank Level Remaining parameter is more than 10 percent.
The Engine Run Time parameter is more than 160 seconds.
The above conditions are met for 1 second.
This diagnostic runs once time per drive cycle once the above conditions are met.