Conditions for Running the DTC

Without RPO JL4

• DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0128, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0200, P0300, P0442, P0446, P0452, P0453, P0455, P0496, P1258 are not set.
• The TP Sensor parameter is greater than 5 percent.
• The ECT Sensor parameter is greater than 60°C (140°F).
• The EVAP Purge Solenoid Command parameter is greater than 1 percent.
• The MAF Sensor parameter is between 20-55 g/s.
• The Engine Speed parameter is between 1,200-3,000 RPM.
• The Loop Status parameter is Closed.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The Fuel Tank Level Remaining parameter is greater than 10 percent.
• The engine run time is more than 160 seconds.
• The above conditions are met for 1 second.
• This diagnostic runs one time per drive cycle once the above conditions are met.

With RPO JL4

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0169, P0178, P0179, P0200, P0220, P0300, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101, P2108, P2135, U0107 are not set.
• The TP Indicated Angle parameter is 5 percent more than the value observed at idle.
• The ECT Sensor parameter is greater than 60°C (140°F).
• The EVAP Purge Solenoid Command parameter is greater than 1 percent.
• The MAF Sensor parameter is between 20-55 g/s.
• The Engine Speed parameter is between 1,200-3,000 RPM.
• The Loop Status parameter is closed.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The Fuel Tank Level Remaining parameter is greater than 10 percent.
• The engine run time is more than 160 seconds.
• The above conditions are met for 1 second.
• This diagnostic runs one time per drive cycle once the above conditions are met.