LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System & Fuel System - 4.8L, 5.3L, And 6.0L - DTC P0452 To DTC P2135) >> DTC P0455 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Refer to the J 41413-200  operation manual for detailed instructions.
  1. Connect the J 41413-200  to the vehicle service port.
  2. Seal the EVAP system and use the flow meter on the J 41413-200  , calibrated to 0.51 mm (0.02 in) to determine that there is no leak in the EVAP system.
    • If a leak is detected, use the J 41413-200  to apply smoke to the EVAP system at the service port until the leak is located.
  3. To test for a restriction, connect the J 41413-200  nitrogen/smoke hose to the J 41413-311  brass cone adapter. Disconnect the hose at the fuel cap end of the GE-41415-50  . Connect the J 41413-311  to the disconnected hose on the GE-41415-50  . Install the GE-41415-50  filler neck end only to the vehicle.
  4. Allow the engine to idle.
  5. Use the Purge/Seal function to seal the system with a scan tool.
  6. Command the EVAP canister purge solenoid valve to 30 percent.
  7. The vacuum/pressure gage on the J 41413-200  and the FTP parameter on the scan tool should both show vacuum.
    • If the vacuum/pressure gage shows vacuum, but the FTP parameter does not show vacuum, replace the FTP sensor.
    • If neither the FTP parameter nor the vacuum/pressure gage shows vacuum, repair the restriction in the purge path. Refer to Evaporative Emissions Hose Routing Diagram .
  8. Verify that the vacuum increases to the abort limit on the scan tool or more than 3.2 volts, and the value is closely similar between the scan tool and the vacuum/pressure gage on the J 41413-200  .
    • If the values are not similar or the voltage did not reach 3.2 volts, replace the FTP sensor.
scientia non olet · About LEMON Manuals