Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
DTC P2510
| ECM Circuits | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| ECM Relay Control | P25101 | 2 | 2 |
| ECM 1 Voltage | 2 | 2 | P25101 |
| Battery Voltage - Switch | 2 | 2 | - |
| Battery Voltage - Coil | 2 | 2 | - |
| 1
DTC will set only after the ECM powers down 2 These circuit faults will cause a loss of communication with the scan tool and a no crank, no start condition. |
|||