Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, observe the scan tool APP sensor 1 parameter for a normal voltage range between 0.89-4.57 volts.
- Ignition ON, observe the scan tool APP sensor 2 parameter for a normal voltage range between 0.41-2.19 volts.
- Ignition ON, compare the scan tool APP sensors 1 and 2 parameters. Verify they do not differ more than 2 percent during a full pedal sweep.
- Engine running, observe the DTC information with a scan tool. DTCs P2122, P2123, P2127, P2128 or P2138 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.