LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0401 To DTC P2510) >> DTC P150C >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Using the DTC Descriptor and Diagnostic Aids, determine which module is not communicating.
  2. Ignition OFF, disconnect the harness connector at the module that is not communicating.
  3. Test for less than 0.5 ohm of resistance between each ground circuit of the module that is not communicating and ground.
    • If greater than 0.5 ohm, repair the open/high resistance in the ground circuit.
  4. Test for battery voltage between each battery positive voltage circuit of the module that is not communicating and ground.
    • If less than battery voltage, repair the short to ground or open/high resistance in the battery positive voltage circuit.
  5. Ignition ON, test for battery voltage between each ignition circuit of the module that is not communicating and ground.
    • If less than battery voltage, repair the short to ground or open/high resistance in the ignition circuit.
  6. Ignition OFF, disconnect the harness connector at the module that reported the no communication DTC.
  7. Ignition OFF, test for less than 0.5 ohm of resistance in each serial data circuit between the module that is not communicating and the module that reported the DTC.
    • If greater than 0.5 ohm, repair the open/high resistance in the serial data circuit.
  8. If all tests normal, replace the module that is not communicating.
scientia non olet · About LEMON Manuals