Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

No throttle position (TP) sensor DTCs P0122 or P0123.
No vehicle speed sensor (VSS) DTCs P0502 or P0503.
No TCC solenoid valve DTC P0740.
No transmission fluid pressure (TFP) manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P2761.
The TP angle is 17-45 percent.
The engine speed is greater than 450 RPM for 6 seconds.
The engine is not in fuel cutoff.
The transmission fluid temperature (TFT) is between 20-130°C (68-266°F).
The engine vacuum is 0-105 kPa (0-15 psi).
The engine torque is 67-542 N.m (50-400 lb ft).
The engine speed is 1,000-3,000 RPM.
The speed ratio is 0.64 to 1.35.
The vehicle speed is 24-80 km/h (15-50 mph).
The gear range does not change within 5 seconds.
The commanded gear is not 1st.
The gear range is D4.
The TCC is commanded OFF.