LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - DTC P0218 To DTC P2761) >> DTC P0724 >> Test Description

Test Description

WARNING: This page is about a different variant/trim than selected.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step isolates the TCC brake switch as a source for setting the DTC.
DTC P0724

Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. With a scan tool.
  2. Turn ON the ignition, with the engine OFF.
    3. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the Failure Records. Using the Clear Info function erases the Failure Records from the PCM.
  3. Record the DTC Failure Records.
  4. Clear the DTC.
  5. Select TCC Brake Switch on the scan tool.
    6. CAUTION: Refer to SIR Caution .
  6. Disconnect the TCC brake switch connector from the TCC brake switch.
Did the TCC Brake Switch status change from Closed to Open?		 - Go to Step 3  Go to Step 4 
3 Replace the TCC brake switch. Refer to Stop Lamp Switch Replacement .
Did you complete the replacement?		 - Go to Step 6  -
4
IMPORTANT: The condition that affects this circuit may exist in other connecting branches of the circuit. Refer to Power Distribution Schematics for complete circuit distribution.
Test the TCC brake switch/cruise control release signal circuit of the TCC brake switch for a short to voltage. Refer to Testing for a Short to Voltage and Wiring Repairs .Did you find and correct the condition?		 - Go to Step 6  Go to Step 5 
5 Replace the PCM. Refer to Control Module References for replacement, setup and programming.
Did you complete the replacement?		 - Go to Step 6  -
6 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Turn ON the ignition, with the engine OFF.
  4. Apply and release the brake pedal.
  5. Verify that the scan tool TCC Brake Switch status indicates Open, 0 volts, for 2 seconds.
  6. Select Specific DTC.
  7. Enter DTC P0724.

Has the test run and passed?		 - Go to Step 7  Go to Step 2 
7 With the scan tool, observe the stored information, capture info, and DTC Info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals