Conditions for Running the DTC

Without RPO JL4

• DTCs P0054, P0060, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0128, P0141, P0161, P0200, P0442, P0446, P0452, P0453, P0455, P0496, P1258 are not set.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The Engine Run Time parameter is greater than 300 seconds.
• The Loop Status is Closed.
• This diagnostic runs one time per drive cycle once the above conditions are met.

With RPO JL4

• DTCs P0054, P0060, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0141, P0161, P0169, P0178, P0179, P0200, P0220, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101, P2108, P2135, U0107 are not set.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The Engine Run Time parameter is greater than 300 seconds.
• The Loop Status is Closed.
• This diagnostic runs one time per drive cycle once the above conditions are met.