With RPO JL4

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0169, P0178, P0179, P0200, P0220, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101, P2108, P2135, U0107 are not set.

• The Loop Status parameter is Closed.
• The Ignition 1 Signal parameter is between 10-18 volts.
• The Fuel Tank Level Remaining parameter is greater than 10 percent.
• Without RPO JL4-The TP Sensor parameter is between 3-70 percent.
• With RPO JL4-The TP Indicated Angle parameter is between 3-70 percent more than the value observed at idle.
• The above conditions are met for 2 seconds.
• This diagnostic runs continuously when the above conditions are met.