Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Install the CH-48027 to the fuel system service port on the right from side of the engine. See Special Tools . Command the fuel pump on, using a scan tool and observe the fuel pressure gage. Fuel pressure should be a minimum of 69 kPa (10 psi) with the fuel pump running.
- Engine running, observe the DTC information with a scan tool. DTC P0230 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.