LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0181 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the fuel temperature sensor.
  2. Turn ON the ignition, with the engine OFF.
  3. Observe the Fuel Temperature parameter with a scan tool.
    • If the fuel temperature is less than -39° (-38.2°F), test the signal circuit for an open or high resistance.
  4. Connect a 3A fused jumper wire between the fuel temperature sensor signal circuit and the low reference circuit.
    • If the fuel temperature is less than 120°C (248°F), test for high resistance in the signal circuit or the low reference circuit.
  5. If all circuits test normal, refer to Component Testing in this diagnostic.
scientia non olet · About LEMON Manuals