LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0117 or P0118 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Under pressure, the temperature of the solution in the radiator can be considerably higher, without boiling. Removing the radiator cap while the engine is hot (pressure is high), will cause the solution to boil instantaneously, with explosive force. The solution will spew out over the engine, fenders, and the person removing the cap. Serious bodily injury may result. Flammable antifreeze, such as alcohol, is not recommended for use at any time. Flammable antifreeze could cause a serious fire.
  1. Turn OFF the ignition.
  2. Inspect the cooling system surge tank for the proper engine coolant level. Refer to Cooling System Leak Testing and Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (Vac N Fill) .
  3. Ignition ON, observe the ECT Sensor parameter. The reading should be between the -39 to +120°C (-38 to +248°F), depending on the current ambient temperature and the vehicle operating conditions.
  4. Use the scan tool to verify the proper operation of the engine cooling system fans.
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.