LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0117 or P0118 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the ECT sensor.
  2. Ignition OFF for 90 seconds, test for less than 5 ohms of resistance between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the control module.
  3. Ignition ON, verify the scan tool ECT parameter is less than -39°C (-40°F).
    • If greater than the specified range, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the control module.
  4. Install a 3A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT parameter is greater than 149°C (300°F)
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the control module.
  5. If all circuits test normal, test or replace the ECT sensor.
scientia non olet · About LEMON Manuals