LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0112 or P0113 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Perform this verification procedure only if the ignition has been OFF for 8 hours or more.
  1. Ignition ON, observe the scan tool IAT Sensor 1, IAT Sensor 2, and ECT Sensor parameters. The readings should be within 8°C (15°F) of each other and also the ambient temperature.
  2. Engine running, observe the DTC information with a scan tool. DTCs P0112 or P0113 should not set.
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.