LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System & Fuel System - 6.6L (LLY) - DTC P0016 To DTC P0341) >> DTC P0106 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: You must perform the Circuit/System Testing in order to verify the integrity of the MAP sensor circuits before proceeding with Component Testing.
  1. Ignition OFF, remove the MAP sensor.
  2. Install a 3A fused jumper wire between the 5-volt reference terminal C and the corresponding terminal of the MAP sensor.
  3. Install a jumper wire between the low reference terminal A of the MAP sensor and ground.
  4. Install a jumper wire at the signal terminal B of the MAP sensor.
  5. Connect a DMM between the jumper wire from terminal B of the MAP sensor and ground.
  6. Ignition ON, with the J 23738-A  or J 35555  , slowly apply vacuum to the sensor while monitoring the voltage on the DMM. See Special Tools . The voltage should vary between 0-5.2 volts, without any spikes or dropouts.
    • If the voltage is erratic, replace the MAP sensor.
scientia non olet · About LEMON Manuals