Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify the integrity of the entire air induction system by inspecting for the following conditions:
- Damaged components
- Loose or improper installation
- Restrictions or leaks in the air induction system
- Water intrusion
- In cold climates, inspect for any snow or ice build-up.
- Engine running, observe the DTC information with a scan tool. DTCs P0102 or P0103 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.